Loading ...
Loading ...
Loading ...
23
USING THE GRILL
EN
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation
Match lighting
If the burner will not light after several attempts, then
the burner can be match lit. If you have attempted to
light the burner with the ignition, allow five minutes for
any accumulated gas to dissipate.
U-burners
Keep your face as far away from the grill as possible while
manually igniting. To manually ignite, pre-light a match
before pushing and turning the control knob to “SEAR”
for the leftmost or rightmost burner. Wait 2 seconds for
gas to prime manual ignition tube, then move match to
10mm in front and a little below the hole located to the
left of the burner (Fig. 14a). If the burner does not light
in four to five seconds, turn knob off, wait five minutes
and try again.
Sear burner (some models only)
Keep your face as far away from the grill as possible. To
light, place a lit butane lighter into the gap between the
grates until the lighter touches the mesh. (Fig. 14b). Push
and turn the knob to “MAX”. If the burner does not light
in four to five seconds, turn knob off, wait five minutes
and try again.
Improper lighting procedures can cause the LP tank flow control to activate resulting in reduced heat
output. If this is suspected the flow control will need to be reset.
Refer to the Troubleshooting section of the user guide if you encounter any difficulties lighting your grill.
1 All knobs must be in the
OFF position.
2 Attach regulator hose
assembly to the tank.
3 Open the LP tank valve.
(Two full turns min).
Resetting the flow control
Grill lighting instructions
IMPORTANT!
• Open the grill hood before lighting. Turn all knobs to “OFF”. Turn the main gas supply on. If you
smell gas, shut-off gas supply and call for customer care. Only light one burner at a time.
Pushing in on the burner knob will activate the Grill Igniter, and then turning the knob from the “OFF”
position will allow the flow of gas to the burner.
The Grill Igniter will glow orange, but there will be no clicking sound during ignition.
Push in and
hold the burner knob for two seconds. Verify that the hot surface ignitor is glowing. Turn the knob
counterclockwise. Release when the burner lights. If the burner does not light in four to five seconds,
turn knob “OFF” and wait five minutes before trying again so any accumulated gas may dissipate.
FIG. 14a
FIG. 14b
Lighting Instructions
Loading ...
Loading ...
Loading ...