Star Micronics SP742ME User Guide

Loading ...

– 15 –

3-8-5. Resetting Bluetooth Settings

The PIN code, device name, and other settings can be reset by following the procedure given below.

(1) While inserting a thin object such as the tip of a pen and holding down the RST button on the rear of the printer, turn

on the printer's power switch. The POWER LED (green) and the ERROR LED (red) on the front of the printer start

ashing.

(2) Hold down the RST button for 4 seconds or more (note 1), and then release it.

PAIR

RST

PAIR

RST

RST button

Hold down for 4 seconds or more

(3) AfteryoureleasetheRSTbutton,iftheLEDstopsashingandthePOWERLEDremainslitgreenwithin12seconds,

initializationiscomplete.IftheLEDcontinuestoashforlongerthan12secondsafterreleasingtheRSTbutton,this

indicates that initialization was not successful. Turn off the printer's power and then try again from step 1.

(4) Turn off the printer's power switch and delete the pairing setup with the master device.

Note 1: In step 2, if you do not hold down the RST button for long enough, initialization will not complete correctly.

For F/W Ver2.0, Ver3.0a, and Ver3.0b interfaces

In step 2, you need to hold down the RST button for 8 seconds or more.

Also, aer nishing steps 1 to 3, to check that initialization was completed correctly, perform self-print-

ing. If the second sheet (*** Bluetooth Information ***) is not printed, initialization has not been com-

pleted correctly. If this happens, turn o the printer's power, and then try again from step 1.

(You can check the firmware version from the self-printing results. See "5-4. Adjustment Mode" for the

self-printing procedure.)

2: Do not turn o the printer during initialization; otherwise initialization will not complete correctly.

3: If initialization is not completed correctly, turn o the printer's power and then try again from step 1.

Loading ...

Star Micronics SP742ME Ethernet LAN Impact Receipt Printer