Loading ...
Loading ...
Loading ...
Chapter 4 General Wiring
Note
●
When you should maintain or disassemble the high voltage modules, you should remove the
enre high voltage modules and maintain it outside the turnsle. You should unplug the cables
that connected to the peripherals before maintenance to avoid destroy of the device.
●
When disassembling the high voltage module, you should disconnect the power to avoid injury.
●
If only wiring is needed without maintenance, do not remove the high voltage modules.
●
The switch and the main lane control board are already connected. The 14 AWG cable to
connect between the AC electric supply and the switch should be purchased separately.
●
2
interconnecng cables are supplied: 24 V Power Cable and Communicaon Cable.
24 V Power Cable: 5 m long, which is in the middle and right pedestal.
Communicaon Cable: 4 m long, CAT5e, which is in the package of middle and right pedestal.
4.1 Components Introducon
By default, basic components of the turnsle are connected well. The pedestals can communicate
by wiring the interconnecng cables. And the turnsle supports wiring the AC electric supply for
the whole system's power supply.
Note
The voltage uctuaon of the electric supply is between 100 VAC and 240 VAC, 50 to 60 Hz.
The picture displayed below describes the serial port on the entrance and exit direcon. You
should select access control board kit for further wiring.
DS-K3Y220(L)X Series Flap Barrier User Manual
8
Loading ...
Loading ...
Loading ...