1. Home
  2. Weber
  3. Weber 9013001 User Manual
  4. Page 14

User Manual - Page 14

For 9013001.

Loading ...
Loading ...
Loading ...
14
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto
weber.com.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the CustomerService
Representative in your area using
the contact information on
weber.com.
Using a Match to Determine if there is Gas
Flow to the Burners
1) Open the grill lid.
2) Check that the burner control knob is in the
o position. Check by pushing in and turning knobs
clockwise.
3) Confirm that the cylinder is properly installed. Refer
to “Installing the LP Cylinder.”
4) Strike a match and put the flame under the
matchlight hole (A).
5) While holding lit match, push the burner control knob
in and turn it counterclockwise to the start/high
position.
6) Check that the burner is lit by looking through the
cooking grates.
7) If the burner does not ignite within 4 seconds, turn
burner control knob to the o
position and wait five
minutes to allow the gas to clear before attempting
to light the burner again. If repeated attempts fail,
follow the gas flow troubleshooting instructions on
the next page.
8) If the burner ignites, the problem lies in the ignition
system. Follow the instructions for “Checking the
Components of the Ignition System.”
GRILL WILL NOT IGNITE
SYMPTOM
• Burner does not ignite when following the ignition instructions in the “Operation” section of this Owner's Manual.
CAUSE SOLUTION
There is a problem with gas flow. If the grill will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this, follow the
instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS NOT successful, follow the gas flow troubleshooting suggestions on the next page.
There is a problem with the ignition system. If the grill will not ignite, the first step is to determine if there is gas flowing to the burners. Tocheck this, followthe
instructions below for “Using a Match to Determine if there is Gas Flow to the Burners.”
If match lighting IS successful, follow the instructions below for “Checking the Components of the IgnitionSystem.”
Checking the Components of the Ignition
System
When pressing the igniter button you should hear it
click. Check the wires to ensure the igniter is creating
a spark.
Checking the Wires
1) Check that the white and black ignition wires are
connected securely to the terminals on the igniter
button behind the control panel (B).
2) Verify the igniter button pushes in, clicks, and
returns out again.
TROUBLESHOOTING
A
B
Loading ...
Loading ...
Loading ...