Loading ...
Loading ...
Loading ...
FRONT PARK/TURN SIGNAL
See the following steps to replace:
1. Remove the front wheel liner fasteners to access
bulb sockets.
2. Turn the socket assembly a quarter turn counter-
clockwise and remove from housing. Pull the bulb
straight from the socket to replace.
NOTE:
We recommend seeing an authorized dealer for service.
LED FRONT SIDE MARKER
See the following steps to replace:
1. Remove the front wheel liner fasteners to access
side maker screw and electrical connector.
2.
Remove fastening screw in the back of the front side
maker assembly and disconnect electrical connector.
3. Remove and replace LED front side marker light
assembly.
FRONT FOG LAMP — IF EQUIPPED
See the following steps to replace:
1. Reach under the vehicle to access the back of the
front fog lamp.
2. Disconnect the wire harness connector from the
front fog lamp connector receptacle.
3. Firmly grab the bulb by the two latch features and
squeeze them together to unlock the bulb from the
back of the front fog lamp housing.
4. Pull the bulb straight out from the keyed opening in
the housing and then connect the replacement
bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil con-
tamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are
replaced as an assembly.
NOTE:
We recommend seeing an authorized dealer for service.
REAR TAIL, STOP, TURN SIGNAL, AND
BACKUP LAMP — IF EQUIPPED
See the following steps to replace:
1. Remove the two screws that pass through the bed
sheet metal.
2. Pull the outboard side of the lamp rearward, far
enough to unsnap the two receptacles on the out-
board side of the lamp housing, from the two plastic
snap post retainers in the outer box side panel.
3. Once removed, locate and rotate the appropriate
socket a quarter turn counterclockwise, then
remove it from the housing.
4. Pull the bulb straight from the socket to replace.
5. To install a new bulb, reverse the procedure above.
Wheel Liner
Tail Lamp Screws
272 SERVICING AND MAINTENANCE
Loading ...
Loading ...
Loading ...