Loading ...
Loading ...
Loading ...
6
Figure 3
Attaching Chute Assembly (Hardware Group A)
• Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit.
• Place chute flange keepers beneath lip of chute
assembly, with the flat side of chute flange keeper
facing downward.
• Insert hex screw up through chute flange keeper
and chute assembly and secure with hex lock nut.
After assembling all three chute flange keepers,
tighten all nuts and screws securely with two 7/16”
wrenches. Do not overtighten. See Figure 4A.
• With the lock nuts loosened on the lower chute rod
bracket (See Figure 4B) adjust the bracket so that
the spiral fully engages the teeth on the chute
assembly. Tighten the lock nuts on the lower chute
rod bracket securely.
Figure 4
Attaching Chute Directional Control
• Remove the hairpin clip from the upper chute rod
and slide the upper chute rod through the upper
chute rod bracket and into the lower chute rod. See
Figure 5.
• Align the two holes on both chute rods and insert
the hairpin clip removed earlier, through these
holes. See Figure 5.
Figure 5
Actuator Brackets and Springs
Wing Nut
Carriage Bolt
Bell Washer
Shift Rod
Connector
Springs
Chute Assembly
Hex Screw
Hex Lock Nut
Chute Flange
Keeper
Chute Directional
Control
Spiral
Lower Chute
Rod
Bracket
A
B
Chute
Assembly
Lock Nuts
Upper Chute Rod
Lower Chute Rod
Hairpin Clip
Upper Chute
Rod Bracket
Loading ...
Loading ...
Loading ...