Loading ...
Loading ...
Loading ...
12
cable) from the drive actuator bracket. See Figure
9.
• Push the cable coupler through the end of the
spring to expose the lock nut. See Figure 10.
• Thread the lock nut outward (down the coupler)
three full turns to provide more slack in the cable
and reattach the spring to the bracket.
• Check the adjustment of the drive control as
instructed earlier. Repeat the previous steps to
provide more slack in the cable, if necessary.
If you are uncertain that you have reached the correct
adjustment, proceed as follows:
WARNING: Drain the gasoline out of your
snow thrower’s engine, or place a piece of
plastic film under the gas cap to avoid spillage
before beginning the job.
• Tip the snow thrower forward, allowing it to rest on
the auger housing.
• Remove the frame cover underneath the snow
thrower by removing six self-tapping screws.
• With the drive control released, make sure there is
clearance between the friction wheel and the drive
plate in all positions of the shift lever.
• With the drive control lever engaged, make sure the
friction wheel solidly contacts the drive plate. See
Figure 11.
Figure 11
If adjustment is necessary, adjust drive control as
instructed below:
• Thread the lock nut outward (down the coupler) to
provide more slack in the cable or thread the lock
nut inward (up the coupler) to provide less slack in
the cable. Refer to Figure 10.
• Reattach the spring to the bracket.
Figure 12
• Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Shift Rod
If your snow thrower is not achieving its full range of
speeds, the shift rod is in need of adjustment. To adjust
the shift rod, proceed as follows:
• Remove the hairpin clip and flat washer from the
shift handle under the handle panel.
• Place shift lever in sixth (6) position (fastest forward
speed).
• Push shift arm assembly down as far as it will go.
• Rotate the ferrule up or down on the shift rod as
necessary until the ferrule lines up with the upper
hole in the shift lever. See Figure 12.
• Insert ferrule from the left side of the snow thrower
into the upper hole.
• Reinstall the hairpin clip and the washer.
NOTE: Make certain to check for correct adjustment
of the shift rod as instructed on page 11—Drive Control
and Shift Lever before operating the snow thrower.
Auger Control
Refer to Auger Control Test on page 10 to adjust the
auger control. Check for correct adjustment as
instructed before operating the snow thrower.
Tire Pressure (Pneumatic Tires)
The tires are overinflated for shipping purposes.
• Check the tire pressure before operating the snow
thrower. Refer to the tire side wall for tire
manufacturer’s recommended psi and deflate (or
inflate) the tires as necessary.
Trigger Cables
Shift Arm
Drive Actuator
Auger Actuator
Hex Nut
Hex Gear Shaft
Drive Plate
Bracket
Bracket
And Cupped
Washer
Friction
Wheel
Shift Lever
Ferrule
Shift Arm
Lower Shift Rod
Clutch Rod
Connector
Hairpin Clip &
Flat Washer
Loading ...
Loading ...
Loading ...