Loading ...
Loading ...
Loading ...
•
•
1,----
~~.:-------------=~-I
-~
= IDS CT S~~'h •
- A•B<: re= =
- INDOOR °C/"F
= USEONLY =
~=
•
. -.
-
-
•
.;
-
-
-
-
-
-
■
•
SETUP
Display Setup
1
Install Sensor Batteries & Set A-B-C Channel
BEFORE powering on the display, install batteries for all wireless sensors
(sold separately) that you would like to synchronize with the display.
NOTE: If pairing more than one wireless sensor with the display, the A-B-C
channel must differ between each sensor. Verify that each sensor has a different
channel selected by following the instructions in the corresponding sensor manual.
2
Install or Replace Display Batteries
Install Sensor Batteries
& Set A-B-C Channel
1
A-B-C
Channel
A-B-C
Channel
1. Remove the battery compartment cover.
2. Insert 3 x AA alkaline batteries into the battery compartment, as shown.
Follow the polarity (+/-) diagram in the battery compartment.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
3. Replace the battery cover.
Install Batteries
3 AA Batteries
2
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
4
Loading ...
Loading ...
Loading ...