Loading ...
Loading ...
Loading ...
7
POWER CONNECTIONS
POWER SOURCE
This planer is equipped with a 15-amp motor for use with a 120-volt, 60-HZ alternating current. See instructions below
regarding proper connections for your saw as wired.
For voltage, the wiring in a shop is as important as the motor’s rating. A line intended ONLY for lights may not be able to
properly carry the current needed for a power tool motor; wire that is heavy enough for a short distance may be too light for
a greater distance; and a line that can support one power tool may not be able to support two or three. A separate electrical
circuit should be used for your machines. This circuit should not be less than #12 wire and recommended to be protected with
a 20-amp circuit breaker or a 20-amp time lag fuse. If an extension cord is used, use ONLY 3-wire extension cords which
have 3-prong grounding-type plugs and matching receptacle which will accept the machine’s plug. Before connecting the
machine to the power line, make sure the switch(s) is in the “OFF” position and be sure that the electric current is of the same
characteristics as indicated on the machine. A substantial voltage drop will cause a loss of power and overheat the motor. It
may also damage the machine.
Your machine is wired for 120 volts, 60 HZ alternating current. Before connecting the machine to the power source, make sure
the switch is in the “OFF” position.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.
This tool has a precision-built electric motor. It should be connected to a POWER SUPPLY THAT IS 120 VOLTS, 60 HZ, AC ONLY
(NORMAL HOUSEHOLD CURRENT in the U.S. and Canada). DO NOT operate this tool on direct current (DC). A substantial
voltage drop will cause a loss of power and the motor will overheat. If the tool does not operate when plugged into an outlet,
double-check the power supply.
ELECTRICAL CONNECTION
POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit
in a polarized outlet ONLY one way. If the plug does not fully fit in the outlet reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. DO NOT change the plug in any way.
1. All grounded, cord-connected machines:
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce
the risk of electric shock. This machine is equipped with an electric cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
DO NOT modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can result in risk of electric shock. The conductor with
insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor. If
repair or replacement of the electric cord or plug is necessary, DO NOT connect the equipment-grounding conductor to a
live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in
doubt as to whether the machine is properly grounded.
Use ONLY 3-wire extension cords that have 3-prong grounding type plugs and matching 3-conductor receptacles that
accept the machine’s plug.
Repair or replace damaged or worn cord immediately.
In all cases, make certain that the receptacle in question is properly grounded. If you are not sure,
have a qualified electrician check the receptacle.
GROUNDING INSTRUCTIONS
This machine must be grounded while in use to protect the operator from electric shock.
Loading ...
Loading ...
Loading ...