GE Profile™ PSB48YSNBSS Smart Built-In Side-by-Side Refrigerator with Dispenser

OWNER’S MANUAL & INSTALLATION INSTRUCTIONS - Page 27

For PSB48YSNBSS. Series: Series 48
Also, The document are for others GE - General Electric models: PSB42, PSB48

PDF File Manual, 104 pages, Read Online | Download pdf file

PSB48YSNBSS photo
Loading ...
Loading ...
Loading ...
49-1000364 Rev. 5 27
INSTALLATION INSTRUCTIONS
Installation Instructions
STEP 1 REMOVE PACKAGING
WARNING
Tip Over Hazard.
The refrigerator is much heavier at the top than at the
bottom—be careful when moving. When using a hand
truck, handle from the side only.
AVERTISSEMENT
Risque de
basculement
La partie supérieure du réfrigérateur est beaucoup plus
ORXUGHTXHVDSDUWLHLQIpULHXUH±6R\H]SUXGHQWORUVTXH
YRXVOHGpSODFH]6LYRXVXWLOLVH]XQFKDULRWPDQXHO
PDQLSXOH]OHUpIULJpUDWHXUSDUOHF{WpVHXOHPHQW
ADVERTENCIA
Riesgo de
Caídas. El refrigerador es mucho más pesado en la
parte superior que en la parte inferior – tenga cuidado al
moverlo. Al usar un carro manual, sostenga el mismo del
ODWHUDO~QLFDPHQWH
• Carefully cut banding at the top and bottom, remove
the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE: ,7,61271(&(66$5<72/$<7+(
&$%,1(7'2:1,125'(5725(029(7+(
6.,'
• The unit is secured to the skid with 4 slotted tie-
GRZQVWUDSV5HPRYHWKHVL[´EROWVIURPWKH
base channels in the tie-downs.
5HPRYHWKHVL[´EROWVVHFXULQJWKHVWUDSVWR
the skid.
NOTE: '2127$77(0377252//81,72))
6.,'
• The support blocks on the
bottom of the refrigeration
case must be removed
before the refrigerator is
taken off the skid or damage
will occur. Carefully tilt the
refrigerator and slide the
blocks out from beneath.
• Remove the toekick and set
aside for final installation.
• Lift the refrigerator off the
skid with an appliance dolly.
Handle from the sides.
Remov
e
Tie Dow
n
Toekick
STEP 2 MOVE THE
REFRIGERATOR INTO THE HOUSE
• Re-use the corner posts from the packaging to
protect stainless steel models. Run the appliance
dolly straps over the posts and under the handles.
• Leave the protective film on the refrigerator until
installation is complete. IMPORTANT: Never lift the
refrigerator by the handle or push against the grille
SDQHOWKLVFRXOGFDXVHGDPDJHRUPLVDOLJQPHQW
• Avoid laying the unit on its back or side to prevent
sealed system restrictions.
STEP 3 INSTALL WATER LINE
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
$WWDFKWXELQJFODPSXVLQJH[LVWLQJKROHRQO\'2
NOT drill into the refrigerator.
AVERTISSEMENT
Raccordez l’appareil à
une alimentation d’eau potable seulement. Une
alimentation d’eau froide est requise pour faire
fonctionner la machine à glaçons et le pichet à
remplissage automatique. La pression d’eau doit se
situer entre 40 et 120 psi. (275 à 827 kPa).
AVERTISSEMENT
RISQUE DE DÉCHARGE
ÉLECTRIQUE
)L[H]OHFROOLHUGHVHUUDJHGDQVOHWURXSUpVHQW
seulement. NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento
de la máquina de hielos automática y de la jarra de
llenado automático. La presión del agua deberá estar
entre 40 y 120 p.s.i. (275 – 827 kPa).
ADVERTENCIA
PELIGRO DE
DESCARGA ELÉCTRICA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
Loading ...
Loading ...
Loading ...