Loading ...
Loading ...
Loading ...
6.5.1. When transporting the machine make sure that no fuel is allowed to leak out.
6.5.2. DO NOT allow the trimmer/brush cutter come into contact with persons, animals
and property.
6.4. STORAGE
If you do not follow these steps, deposit may arise in the carburetor. This will cause
starting difficulties and may cause permanent damage.
6.4.1. Perform all the general maintenance that the maintenance section of your ‘User
Manual’ is recommended.
6.4.2. Clean the outside of the machine, drive axle, shield and nylon cutting head.
6.4.3. Remove all fuel from the fuel tank.
6.4.4. After all the fuel has been removed from the fuel tank. Start the engine. Allow the
engine to run in idle until engine
stops alone. This allows the fuel to be removed from the
carburetor.
6.4.5. Allow the engine to cool down for about five minutes.
6.4.6. Remove the spark plug and pour 1 teaspoon of clean oil into the combustion
chamber. Slowly pull the starter rope several times to coat internal components. Replace
the spark plug.
6.4.7. Store the machine in a cool, dry place away from any source of ignition such as an oil
burner, water heater, etc.
6.5. TRANSPORTING THE MACHINE
Page 28
Loading ...
Loading ...
Loading ...