Loading ...
Loading ...
Loading ...
Page 26
The spark plug MUST be fully
ened otherwise the engine will overheat causing damage.
Always complete the following steps
r the engine has been turned off and allowed to cool
down.
6.2.1. To make sure the engine runs correctly a spark plug gap of 0.6 -0.7 mm must be
maintained and the spark plug must be free of carbon deposits.
6.2.1. To remove the spark undo the cover then pull back the protec
e cover. Pull off the
HT lead and then undo the spark plug using the supplied box spanner in an an
-clockwise
direc
.
6.2.3. Once the plug has been removed check it for visual damage, electrode wear and
carbon deposits. Replace a damaged or badly worn spark plug. Clean off any carbon deposits
by using a so
brass brush.
6.2.4. Check the gap with a feeler gauge and adjust electrode at the correct gap of 0.6 -0.7
mm.
6.2.5. Check the washer (replace as required) of the spark plug. Refit the spark plug by hand
to make sure it does not cross thread, spark plug to a torque of 12/15Nm.
6.2.6. To refit spark plug reverse the above process.
6.2. SPARK PLUG
HT lead
Remove spark
plug using
supplied box
spanner
Loading ...
Loading ...
Loading ...