Loading ...
Loading ...
Loading ...
8
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
5.0 Setup and assembly
5.1 Shipping contents
See Figures 5-1 and 5-2.
1 Stand (not shown)
1 Band saw (not shown)
1 Table – A
1 Table insert (preinstalled in table) – B
1 Handle – C
1 Dust chute – D
1 Fence body – E
1 Resaw fence – F
1 Fence rail – G
4 Rubber feet with hex nut (not shown)
4 Hex wrenches, 2.5/4/5/6mm (not shown)
1 Operating Instructions and Parts Manual
1 Product registration card
1 Hardware package (JWBS14SFX-HPN):
4 Socket hd cap screws M8x50 – HP1
12 Hex cap screws M8x16 – HP2
4 Socket hd button screws M8x20 – HP3
4 Socket hd button screws M5x8 – HP4
24 Flat washers 8mm – HP5
13 Hex nuts 8mm – HP6
4 Lock washers 8mm – HP7
1 Hex cap screw M8x65 – HP8
Figure 5-1: contents (not to scale)
Figure 5-2: hardware package JWBS14SFX-HPN
5.2 Tools required for assembly
(Note: Additional tools may be needed for
adjustments.)
5mm, 6mm hex wrenches (provided)
13mm,14mm wrenches
Rubber mallet (or hammer and block of wood)
Straight edge
Measuring tape or gauge
Machinists square (or similar 90°measuring device)
5.3 Unpacking and cleanup
Open boxes and inspect contents. Report any
shipping damage or missing parts to your
distributor. Do not discard packing material until
machine is assembled and running satisfactorily.
The band saw should be located in a dry, well lit
area, with enough room to handle long stock and
servicing or adjustment of the machine from any
side.
Clean off any rust-protectant with a mild solvent or
kerosene and a soft cloth. Do not use lacquer
thinner, paint thinner, or gasoline, as these will
damage painted surfaces.
Band saw must be
disconnected from power source during
assembly procedures. Failure to comply may
cause serious injury.
5.4 Assembling stand
Assemble stand by referring to exploded view in
sect. 13.1.3. Use fasteners HP2/5/6/7 and rubber
feet, as shown. Adjust the rubber feet as needed to
level the band saw.
Carefully raise the saw using straps with a forklift or
hoist, and secure it to the stand with screws and
washers HP1/5/7. See Figure 5-3.
5.5 Installing handle
Thread handle (C, Figure 5-1) into front handwheel,
and tighten with 13mm wrench on flats.
Loading ...
Loading ...
Loading ...