Loading ...
Loading ...
Loading ...
13
13. Turn stop screw (HP6) until it contacts saw
frame, and tighten hex nut (HP8) against table.
14. If needed, loosen screw and move pointer (M,
Figure 5-15) to align with zero on scale.
Retighten screw.
Figure 5-15: table alignments
Figure 5-16 squaring table to blade
5.16 Installing guide rail and fence
1. Partially install four hex cap screws with
washers (HP2/5, Figure 5-17) into threaded
holes beneath front table edge. Leave gap
between table and screw head.
2. Slide fence rail onto screws and against table,
as shown in Figure 5-17. Tighten screws.
Figure 5-17
4. Slide fence body onto end of guide rail (Figure
5-18) and push down handle to lock fence body
to rail. There should be an even gap between
table surface and the length of fence body.
5. If adjustment is needed, use the set screws
which are located next to the fence body screws
(E
3
, Figure 5-19). Loosen the four screws (E
3
)
and turn any of the four adjoining set screws in
or out as needed, until fence is flat against
blade.
6. Tighten screws (E
3
).
Figure 5-18
7. Loosen handles (E1, Figure 5-19) and slide
fence onto bar. Tighten handles (E
1
).
5.16.1 Fence to miter slot alignment
8. Slide fence against edge of miter slot (Figure 5-
19) and push down handle (E
2
) to lock position.
The fence should align parallel to miter slot
along entire length of fence.
9. If adjustment is needed, loosen four screws (E
3
,
Figure 5-19) and shift fence body as needed to
align fence with miter slot.
10. Tighten screws (E
3
).
Figure 5-19
5.16.2 Fence to blade alignment
11. Set table at 90° to blade and lock in position.
12. Move fence against blade (do not deflect blade
by pushing into it). See Figure 5-20.
13. Verify that fence, top-to-bottom, lies flat against
side of blade. If it does not, use the set screws
which are located next to the fence body screws
(E
3
, Figure 5-19). Loosen the four screws (E
3
)
and turn any of the four adjoining set screws in
or out as needed, until fence is flat against
blade.
Loading ...
Loading ...
Loading ...