Loading ...
Loading ...
Loading ...
20
10.0 User-maintenance
Before any intervention on the
machine, disconnect it from electrical supply by
pulling out the plug. Failure to comply may
cause serious injury.
Clean band saw regularly to remove any resinous
deposits and sawdust.
Keep miter slot and guide bearings clean and free
of resin.
Keep blade clean and sharp. Check it periodically
for cracks or other signs of wear.
The drive belt should be checked periodically. If it
looks worn, frayed, glazed or otherwise damaged,
replace it.
Check that the cleaning brush over the band wheel
is working properly, and remove any deposits from
the band wheels to avoid vibration and blade
breakage.
Do not allow saw dust to build up in the upper and
lower wheel housings. Vacuum or blow out dust
from inside cabinet. (Use proper dust mask
equipment).
The table surface must be kept clean and free of rust
for best results. If rust appears, it can often be
removed with a mixture of household ammonia,
good commercial detergent and #000 steel wool.
Alternatively, commercial rust removers can be
found at many hardware stores.
Periodically apply a light coat of paste wax or other
non-silicone protectant to the table surface. Select a
product that will protect the metal and provide a
smooth surface, without staining workpieces.
If the power cord is worn, cut, or damaged in any
way, have it replaced immediately.
Connect the band saw to a dust collection system of
appropriate capacity. (See our website for a full line
of JET dust collectors.)
Periodically vacuum out the motor fan cover.
10.1 Lubrication points
1. Periodically apply a light, multi-purpose grease
to the following:
Rack and pinion system of guide post.
Sliding surfaces of table trunnions.
2. Oil any pins, shafts, and joints. (Do not get oil
on pulleys or belts.)
3. Clean and oil the blade tension mechanism if it
becomes difficult to adjust.
Note: Bearings on the band saw are pre-lubricated
and sealed, and do not require attention.
10.2 Additional servicing
Any other servicing should be performed by an
authorized service representative.
Loading ...
Loading ...
Loading ...