Loading ...
Loading ...
Loading ...
14
DO
❑ DO check inlet gas pressure to ensure
that it is within the range specified on the
rating plate.
❑ DO provide adequate air for combustion
and ventilation as discussed in the Use and
Care Manual and the National Fuel Gas
Code.
❑ DO maintain proper clearances to
combustibles as specified on the rating
plate.
❑ DO ensure that the venting system
complies with the guidelines found in the
Use and Care Manual and National Fuel
Gas Code.
❑ DO contact a qualified service
technician if the pilot or main burner will
not stay lit. The burner chamber is designed
to be sealed utilizing a gasket and tamper
resistant screws.
DON’T
❑ DON’T block or restrict Combustion
Air Inlet Openings located around the lower
portion of the water heater jacket.
❑ DON’T remove the Burner Access
Door unless absolutely necessary. This
should only be done by a qualified service
technician. A new burner access door gasket
must be installed on any burner access door
that has been removed.
❑ DON’T install this water heater where
standing water may occur. The base of the
water heater is meant to be mounted on a
dry surface.
❑ DON’T operate the water heater if the
sight glass or pilot assembly door grommet
is damaged or broken.
During Installation of this water heater.
Sight Glass
Pilot Assembly
Door Grommet
Installing the water heater.
Loading ...
Loading ...
Loading ...