Loading ...
Loading ...
Loading ...
Using Quick Sampling
PSR-E473, PSR-EW425 Owner’s Manual
44
5
Press the pad that is flashing to start
sampling.
“Sampling” appears on the display.
6
Start playback on the external device, or
input sound to the microphone.
7
Stop audio input at the end of the sound
or phrase you want to sample.
If you are using an external device, stop play-
back. If you are using a microphone, stop input-
ting sound to it.
8
Press the lit pad again to stop sampling.
“Writing!” appears briefly on the display, and then
the sample is overwritten and stored. The pad’s
light goes off, the sampling ends, and the instru-
ment returns to the status described in Step 2.
9
Press the [CAPTURE] button to exit
Quick Sampling mode.
10
Press the Quick Sampling pad to play
back the sample.
Do not disconnect the USB flash drive during the sam-
pling operation. The operation of the instrument may
become unstable, and sampling may not be performed
properly.
You can also press the [ENTER] button to start sampling.
If the input volume from the external device or microphone
is too low, “LowInput” appears on the display and sam-
pling is canceled. Then, the instrument returns to the status
described in Step 3.
Sampling time is limited to a maximum of 9.6 seconds.
When the time limit is reached, sampling stops automati-
cally and the recorded sample (up to that point) is stored to
the instrument.
Sampling
Flashes
NOTICE
NOTE
NOTE
PressA−D
Writing!
NOTE
To sample during audio playback
Once you are familiar with the sampling operation,
streamline the operation by starting and stopping sam-
pling while the sound of the external device is playing
back.
1. Perform Steps 2 and 3 of “Sampling External Audio”
(page 43).
2. Stop playback on the external device a few measures
before the sound or phrase you want to sample.
3. Start playback on the external device.
4. Press the pad that is flashing at the point where you
want to start sampling.
5. When you want to stop sampling, press the pad again.
6. Stop playback on the external device, and then check
what you have just sampled.
If there is silence that you want to keep it in the sample, but
is cut automatically, set “BlankCut” in the Function Settings
(page 64, Function 048) to “OFF.”
NOTE
Loading ...
Loading ...
Loading ...