Loading ...
Loading ...
Loading ...
40 41
2. Route aircraft seat belt through belt path.
Route the aircraft seat belt through the belt path
opening in the back of the child restraint and
continue through the opening on the opposite side
of the child restraint.
Note: Lift the restraint’s seat pad away for easier access.
Aircraft
Seat Belt
Belt Path
Opening
Installing Child Restraint in Aircraft
3. Fasten the aircraft seat belt, then remove
all slack from the belt.
The aircraft seat belt must be as tight as possible. Route
the excess aircraft seat belt strap back through the belt
path opening. Using your full weight, push the child
restraint firmly onto the aircraft seat while pulling on the
excess seat belt strap to tighten.
Note: Because of the fixed length of aircraft seat belts, the
belt buckle could be behind the child’s back after tightening
the belt. For your child’s comfort, Evenflo recommends
cushioning the child’s back by placing a small pillow or
folded-up blanket, or a folded-up jacket, over the belt buckle.
Check your work:
Reconnect the seat pad to the front
of the child restraint. Try to move the child restraint in all
directions. If you can move the restraint more than 25 mm
(1 in) from side-to-side or front to back at the belt path,
the aircraft seat belt is not tight enough, and you MUST
install again until the seat belt is tight.
Care and Cleaning
• DO NOT lubricate or immerse in water the LATCH
connectors, the buckle, or any other part of this child
restraint, unless rinsing is permitted, as stated on the back
of the buckle for your restraint.
• Plastic and metal parts may be wiped clean with mild
soap and water and dried with a soft cloth. Do not use
abrasive cleaners or solvents.
• Take care not to damage any labels.
• The harness can be wiped clean with mild soap and
water. Allow harness to air dry.
• Machine wash the seat pad separately in cold water,
delicate cycle. Tumble dry 10 to 15 minutes on low
heat.
• NEVER use child restraint without the seat pad.
• To protect the child restraint from damage caused by
weather, rodents, and other elements common to
garages, the outdoors, and other storage locations,
remove the seat pad and thoroughly clean the
restraint and pad prior to storage. Take care to clean
in the areas where crumbs and other debris tend to
accumulate.
4. Secure Your Child in the Child Restraint.
Refer to page 22.
Loading ...
Loading ...
Loading ...