Loading ...
Loading ...
Loading ...
36 37
Canadian Models Only
Leveling the Booster Seat
Screw
Installing the Cup Holders
General Information
If the level line is not
parallel to the ground,
before fastening the
child restraint to the
vehicle seat, place a
tightly rolled towel/
small blanket beneath
the bottom rear of
the booster seat, as
shown.
Place each cup holder
onto the seat, then
turn the seat over
and secure each cup
holder with a screw, as shown. Do not over tighten.
Make sure each cup holder is attached securely in place.
Towel/Small Blanket
Level Line
Shoulder belt routing while in booster
mode
While the seat is used in booster
mode the shoulder belt must be
routed over the child’s shoulder.
The belt must pass under the
head rest, between the head rest
and the seat as long as the child’s
shoulders are at or below the
opening between the head rest
and shell.
If the child’s shoulders are
high enough that routing
the shoulder belt under
the head rest causes the
belt to be pulled down
the back side of the
child’s shoulder (before
passing through the head
rest), the belt should not
be routed between the
seat and the head rest.
If the shoulder height causes the
belt to route behind the back
and the top of the ears are still
at or below the top of the head
rest, the shoulder belt should be
routed on top of the head rest.
Not available on all models.
Loading ...
Loading ...
Loading ...