Loading ...
Loading ...
Loading ...
SHARPENING CUTTER BLADES
The blades can be honed individually with an ordinary
oilstone.
Make sure your oilstone is not worn in the center. Itmust
be fiat.
Be sure to remove the burr on the fiat side.
/
/
/
If the blades are nicked, they must be replaced or
reground. They can be regrounded several times until
they become 9/16 in. wide. Never install reground blades
less than 9/16 in. wide or unbalanced blades.
Have your knives reground by someone who is competent.
Look in the "Yellow Pages" of your telephone directory...
see "Sharpening Services".
11116 IN,
NEW BLADE
........................................ i1=rll i=
general maintenance
Keep your jointer_planer clean. Put a carton or some kind
of a container underneath your jointer-planer to catch the
chips. The container should reach above the top of the
motor.
Do not allow pitch to accumulate on the tables, the fence.
the cutter guard, the cutter head or the knives. Clean them
with Craftsman Gum and Pitch Remover.
Apply a thin coat of paste type wax to the tables and fence
so that the wood slides easily while feeding.
Do not atlow chips to accumulate on the underside of the
jointer-planer.
Frequently biow out any dust that may accumulate inside
the motor.
If power cord iis worn or cut, or damaged in any way, have
it replaced immediately:
lubricaUon
The BALL BEARINGS in this machine are packed with
grease at the factory. They require no further lubrication.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
1. Dovetail spacer and dovetail slide.
2. Elevating screw (first clean with Craftsman Gum and
Pitch Remover).
DOVETAIL
SPACER AND SLIDE
ELEVATING SCREW '
VIEW LOOKING UP FOR
PARTS IDENTIFICATION
Loading ...
Loading ...
Loading ...