Loading ...
Loading ...
Loading ...
MOTOR
CORD
t
e. Plug motor cord into outlet in switch box,
OUTLET
-- i i _1 ii ___
basic jointer-planer operation
POWER
CORD
WARNING: For your own safety, ALWAYS use the hold
down/push blocks when JOINTING wood that is
NARROWER than 3 tn.... or when PLANING wood that is
THINNER than 3 in.
Do not plane, joint or bevel wood shorter than 12 in.
Material this short ismore difficult to control while being
cut. Small pieces of wood can tip over on the tables orinto
, , , i
the cutterhead and can be kicked back toward you.
For your own safety, never operate this tool with the fence
or guards removed.
For best results, take light cuts. For average planing,
jointing, or beveling, a cut between t/32 and t/16 in. deep
will produce the best results.
FEEDING THE WORKPIECE
Hold the board firmly DOWN on both tables and AGAINST
the fence.., keep fingers close together.
Feed the boa rd at a continuous even rate of speed until the
cut is made along the entire length of the board. Any
hesitation or stopping could cause a "step" to be cut on
the edge of the board which would cause the board to ride
up on the outfeed table resulting in a "crooked" edge on
the board.
i1,1 , iiil,,irl
JOINTING WOOD THAT IS WIDER THAN 3 IN.
As the RIGHT hand passe s over the cutterhead, remove
the LEFT hand... CONTINUE feeding while placing the
LEFT hand behind the RIGHT. Continue feeding in this
manner "hand over hand", until the entire length of the
board is cut. Pressure should be applied over the cutter-
head and outfeed table.
DO NOT FEED TOO FAST. A stow steady: rate of feed
produces a smooth accurate cut. Feeding too fast causes
a "rippled" cut,., makes it difficult toguide the workpiece ....
accurately and could be hazardous.
i i iiii iii1,1 i ,HI
PLANING WOOD THAT IS THICKER THAN 3 IN.
SUPPORT LONG WORKPIECES
17
Loading ...
Loading ...
Loading ...