Loading ...
Loading ...
Loading ...
12
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
24V‑X4‑SB21‑CT cordless snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1‑866‑SNOWJOE (1‑866‑766‑9563).
mWARNING! Make sure to turn off the switch and remove
the batteries before performing any maintenance task on your
snow blower.
General Maintenance Tips
• Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
• Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
• After each snow removal, shut off the motor, wait for all
revolving parts to stop completely, remove the batteries and
wipe residual ice and snow off the unit.
Proper Care for Batteries + Chargers
mWARNING! To reduce the risk of injury, always unplug
the chargers and remove the battery packs from the charger
before performing any maintenance task. Never disassemble the
battery pack or charger. Contact your Snow Joe
®
+ Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer service center for
ALL repairs.
• To reduce the risk of injury and damage, never immerse
your battery packs or charger in liquid or allow any liquid to
flow inside these components.
• Clean out dust and debris from chargers vents and
electrical contacts by blowing with compressed air.
pattern A
pattern B
Fig. 18
• Use only mild soap on a damp cloth to clean the battery
packs and chargers, keeping away from all electrical
contacts. Certain cleaning agents and solvents are harmful
to plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and household
detergents containing ammonia. Never use flammable
or combustible solvents around battery packs, battery
chargers or tools.
• The 24V iON+ lithium‑ion battery chargers have no
serviceable parts.
Replacing Scraper Bar
IMPORTANT! Damage to auger housing will result if the scraper
bar wears down too far.
To replace scraper bar:
1. Position unit on a hard, flat, smooth level surface.
2. Detach the worn scraper bar from the snow blower by
removing the 4 sets of nuts, washers and bolts that hold it
in place (Fig. 19).
3. Install the new scraper bar and fasten it securely to the snow
blower with the original sets of nuts, washers and bolts.
Replacing Auger Blades
During use, the auger blades will wear down over time, which
will eventually cause incomplete cleaning. If the unit cannot plow
snow completely and leaves snow on ground, consider changing
the auger blades.
Scraper
blade
Fig. 19
Loading ...
Loading ...
Loading ...