Loading ...
Loading ...
Loading ...
ENGLISH
8
Fig. B
15
15
31
18
30
30
31
6
4. Attach high pressure hose
16
to spray gun. Make sure
it issecure.
OR
Fig. C
16
5. Connect wand
5
to spray gun. Make sure connection
issecure.
Fig. D
5
6. Place the nozzle holder
2
onto the panel assembly
1
and push each nozzle holder intoplace.
Fig. E
1
2
7. Remove the five colored quick-connect nozzles from the
plastic bag and insert them into correct grommet on the
nozzle holder. Nozzles are color coded to match colored
nozzles on panelassembly.
Fig. F
NOTE: The high pressure pump was filled with oil at
the factory. Always check oil level before using (refer to
Maintenance for more information).
WARNING: Risk of bursting. Use a tire pressure gauge
to check the tires pressure before each use and while
inflating tires; see the tire sidewall for the correct tire
pressure.
NOTE: Air tanks, compressors and similar equipment used
to inflate tires can fill small tires similar to these very rapidly.
Adjust pressure regulator on air supply to no more than the
rating of the tire pressure. Add air in small increments and
frequently use the tire gauge to prevent overinflation.
OPERATION
Pressure Adjustments
The pressure setting is preset at the factory to achieve
optimum pressure and cleaning. To lower the pressure,
follow theseinstructions.
1. Back away from the surface to be cleaned. The further
away you are, the less the pressure will be on the
surface to becleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a
less powerful stream of water and a wider spray pattern.
Refer to Spray WandNozzles.
3. This pressure washer's high pressure pump is equipped
with an adjustable unloader feature that allows
the pressure setting to be adjusted. To lower the
pressure, turn the pressure control knob on the pump
counterclockwise to the desired pressure. To return the
pump pressure to the factory setting, turn the pressure
control knob on the pump clockwise until itstops.
NOTICE: DO NOT try to tum pressure regulator
knob past the built-in stop or damage to the pump
willresult.
NOTICE: DO NOT overtighten the pressure control
knob. If overtightened the knob COULD break and
result in immediate loss of water pressure and costly
repairs to theunit.
NOTICE: DO NOT attempt to increase pump pressure.
A higher pressure setting than the factory set pressure
may damage thepump.
-
Fig. G
+
Spray Wand Nozzles (Fig. A, H)
The nozzles for the spray wand are stored in the nozzle
holder
2
on the panel assembly
1
. Colors on the panel
identify nozzle location and spray pattern. Refer to the
Loading ...
Loading ...
Loading ...