Loading ...
Loading ...
Loading ...
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assemblyof your
pressurewasher, please call the pressurewasher heipline
at 1-800-222-3135.
UNPACKTHE PRESSUREWASHER
1. Remove everything from carton except pressure washer.
2. Opencarton completely by cutting each corner from top
to bottom.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach spray tip extension to spray gun.
9. Select/attachquick connect spray tip to spray tip
extension.
Attach Handle and Accessory Tray
1. Placehandle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handlealign with holes
(C) on handle supports.
3. Remove pressure washer from carton.
CARTONCONTENTS
Checkall contents, if any parts are missing or damaged,call
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Accessory Tray
* High PressureHose
* Spray Gun
* Spray Tip Extension with Quick Connect Fitting
* Oil Bottle
* HoseWrap
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* Safety Goggles
* Bottle BracketWireform
* PerfectMixTM Siphoning Unit/Hose
* DetergentSiphoning Hose/Filter
* Bagcontaining 4 multi-colored Spray Tips
* HandleFasteningHardwareKit (whichincludes):
* Handle Bolts (2)
* Carriage Bolt (1)
* Plastic Knobsfor Handle (2)
* Rope Guide (1)
* Plastic Knob (2)
* Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLINGPRESSUREWASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handleand accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
Insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store flat atop the cold engine. Note:
DO NOTfold the handle down while the engine is hot.
Placeaccessory tray (F) over holes (G) on handle
(viewing from back of unit). Push the tree clips (H) into
the holes until they sit flat againstthe accessory tray.
Insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to UseAccessory Tray.
Loading ...
Loading ...
Loading ...