Loading ...
Loading ...
Loading ...
29
ENG
Changing The Program Mid-cycle
A wash cycle can only be changed if it has been running for a short time otherwise, the detergent may have already
been released and the dishwasher may have already drained the wash water. If this is the case, the dishwasher
needs to be reset and the detergent dispenser must be refilled. To reset the dishwasher, follow the instructions
below:
1. Open the door a little to stop the dishwasher, after the spray arm stopped working, you can open the door
completely.
2. Press Program button more than three seconds the machine will be in program selection mode
3. You can change the program to the desired cycle setting.
Starting a program
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the lower
basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page”Product fiche”. Make sure that the water
supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the dishwasher will start
its cycle.
It is dangerous to open the door mid-cycle, as hot steam may scald you.
WARNING!
Forget To Add A Dish?
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the
instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stopped working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door, the dishwasher will continue to run after 10 seconds.
3 sec
Loading ...
Loading ...
Loading ...