Loading ...
Loading ...
Loading ...
20 INSTALLATION
Connecting Water Supply
1Before connecting, turn off the water supply.
2Slide the exible stainless-steel water line or
copper tube into the elbow.
3Tighten the compression nut and make sure that
the line is not kinked or pinched.
Valve Water supply
line
NOTE
•During the nal installation check of the dishwasher,
an IE error code may appear on the display. Make
sure the water line is not kinked and the water
supply for the dishwasher has been turned on
before calling for service.
Connecting Power
NOTE
•The best location for the electrical conduit is on the
right side of the back wall. Re-route the power cable
before installation if the electrical conduit pipe is
longer than 3" (76 mm) and is centered on the back
wall.
1Before beginning, turn off electrical power to the
unit at the circuit breaker.
2Remove the junction box cover and then install
the strain relief.
1 2
3Twist the wire nuts tightly onto the wires; then
wrap each connection with electrical tape.
1 2 3 4
4Check again and make sure that all wires are
connected correctly: black to black, white to
white, green ground wire to green ground wire.
5Replace the junction box cover.
WARNING
•Verify that the black wire is hot (120 V). If not,
or if you are unsure of the power supply, have it
checked by a licensed electrician.
CAUTION
•Do not leave stripped wire exposed. Trim
stripped wire to t completely inside wire nuts.
Loading ...
Loading ...
Loading ...