Loading ...
Loading ...
Loading ...
8
13. CONNECT WIRING
WARNING
!
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power from being switched on accidentally.
Position the power pack below the installed custom hood.
DUAL BLOWER UNIT: Remove the screw retaining the electrical compartment cover.
Lift out the cover and install the wire clamp (included in parts
bag). Insert the house wiring cable through the wire clamp and
tighten to secure the cable.
SINGLE BLOWER UNIT: Position the power pack below the installed custom hood. Insert the house wiring cable through the wire clamp
previously installed in step 10. Tighten the wire clamp to secure the cable.
ALL UNITS: Connect cable using provided wire connectors. Connect wires as follow:
BLACK to BLACK, WHITE to WHITE and GREEN or BARE wire under
ground screw (A). DO NOT FORGET TO CONNECT THE GROUND.
DUAL BLOWER UNIT: Reinstall the electrical compartment cover.
14. INSTALL THE POWER PACK
CAUTION
Take care not to kink ducting or pinch electrical wire when installing the power pack.
Lift the power pack in custom hood until the bottom of the clasping springs (2 per side) rests
on the top of the custom hood base (grey zone in illustration at right).
HO0134
RETAINING SCREW
HE0059
A
HD0362
CLASPING SPRINGS
HH0124
From inside the power pack, using provided no. 8-10 x 1/2” screws, mount thepower pack
to the custom hood base. To do so, lift one side until its flange rests on the outer side of the
custom hood base and use 2 screws to secure in place.
Do the same for the other side, then finalise mounting with 2 other screws for each side.
See figure at right for mounting screws specific locations.
VERTICAL EXHAUST INSTALLATION ONLY
Make sure the adapter/damper enters the ducting and the damper opens freely.Wherever it
is possible, seal connections with metal foil duct tape.
Loading ...
Loading ...
Loading ...