Loading ...
Loading ...
Loading ...
Hand Movement and
Indications
Q1
I don’t know what mode the watch is
in.
Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
●
Take care not to hold down (C) too long.
Holding down (C) for about four seconds will
enter or exit the Airplane Mode.
l Navigating Between Modes
30
Q2
The second hand is jumping at two-
second or five-second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
l Charging the Watch
Q3
All hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
l Charging the Watch
Q4
The hands suddenly start moving at
high speed.
This is due to one of the reasons below, and
does not indicate malfunction. Simply wait
until normal hand movement resumes.
●
The watch is recovering from a power
saving state.
l Power Saving Function
●
The hands are moving to their new positions
following a GPS signal or time calibration
signal receive operation.
l Time Adjustment (GPS, Time Calibration
Signal)
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q6
The current time displayed by the
watch is off by a few hours.
The city (time zone) setting is not correct.
Select the correct setting.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
Q7
The current time indicated by the
watch is off by one hour or 30
minutes.
The summer time setting is not correct. Select
the correct setting.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
Q8
Hands and/or the day indicator is out
of alignment.
Strong magnetism or impact may cause the
hands of the watch to go out of alignment.
Correct hand position alignment.
l Adjusting Hand and Day Indicator
Alignment
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
and day indicator alignment operations),
crown operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again.
l Using the Crown
Operation Guide 5411
14