Loading ...
Loading ...
Loading ...
Q3
The signal receive operation always
fails.
Is the watch in a location that is appropriate
for signal reception?
Check your surroundings and move the
watch to a location where signal reception
is better.
l Appropriate Signal Reception Location
Is the face of the watch pointed straight
upwards at the sky?
Minimize movement of the watch while the
receive operation is in progress.
When the watch is set up for auto receive,
take care to avoid covering the watch face
with the sleeve of your clothing.
An alarm started sounding while the
receive operation was in progress.
Receive stops if an alarm operation starts
while it is being performed. Disable the
alarm.
l Enabling/Disabling the Alarm
Q4
Signal reception should have been
successful, but the watch’s time and/
or day is wrong.
Is your Home City (time zone) setting
correct for your location?
Change your Home City (time zone)
setting so it correctly indicates your
location.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
After checking the above, the time and/or
day settings is still wrong.
Adjust time and day settings manually.
Signal Reception (Time
Calibration Signal)
Q1
The watch cannot perform a receive
operation.
Is the watch’s battery charged?
Signal reception is not possible while
battery power is low. Keep the watch
exposed to light until it recharges
sufficiently.
Is the watch in the Timekeeping Mode (not
Airplane Mode)?
Signal reception is possible only while the
watch is in the Timekeeping Mode (not
Airplane Mode).
Is your Home City (time zone) setting
correct for your location?
The watch will not indicate the correct time
if the Home City (time zone) setting is
wrong. Change your Home City (time
zone) setting so it correctly indicates your
location.
l Acquiring GPS Position Information
Manually
l Selecting a Time Zone
After checking the above, the watch still
cannot perform a receive operation.
Time calibration signal reception is not
possible under the conditions described
below.
●
When watch is at Level 2 power saving
●
When the crown is pulled out
●
While the watch temperature is less
than approximately -10°C (14°F) or
more than approximately 60°C (140°F)
If successful reception is not possible for
some reason, you can adjust the time and
day settings manually.
Q2
The signal receive operation always
fails.
Is the watch in a location that is appropriate
for signal reception?
Check your surroundings and move the
watch to a location where signal reception
is better.
l Appropriate Signal Reception Location
Did you avoid touching the watch while the
receive operation was in progress?
Minimize movement of the watch and do
not perform any watch operation while a
receive operation is in progress.
Is there an alarm configured to sound
during the same period that the signal
receive operation is performed?
Receive stops if an alarm operation starts
while it is being performed. Disable the
alarm.
l Enabling/Disabling the Alarm
Is the signal transmitter in your area
transmitting a signal?
The transmitter of the time calibration may
not be transmitting a signal.
Try again later.
Alarms
Q1
The alarm does not sound.
Is the watch’s battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
The crown is pulled out.
The alarm will not sound while the crown
is pulled out. Push the crown back in to its
normal position.
Operation Guide 5411
13
Loading ...