Loading ...
Loading ...
Loading ...
SECTION2: ASSEMBLINGYOURSNOWTHROWER
LooseParts
Figure 1 shows parts of the snow thrower packed loose
in the carton. You will need these parts along with
hardware from the hardware pack, illustrated on the
next page, to assemble the equipment. Identify the
loose parts before proceeding to assemble.
Handle Panel
/ L..o.Sion
Chute Directional
Control Shift Rod
Clean-out
Discharge
Chute
Figure 1
1. Right and Left Handles
2. Handle Panel Assembly
3. Chute Assembly
4. Chute Directional Control Assembly
5. Shift Rod
6. Hardware Pack
7. Clean-out Tool*
8. Extension Cord*
*This item is fastened with a cable tie to the rear of
the Auger Housing at the factory. Cut the cable tie
before operating the snow thrower.
ToolsRequiredForAssembly
1. Pair of pliers
2. Two adjustable wrenches
,_ WARNING: Disconnect spark plug wire
and ground it against the engine to prevent
unintended starting.
NOTE: All references to right or left side of the snow
thrower are determined from behind the unit in the
operating position. The "operator's position" is defined
as standing directly behind the snow thrower, facing the
handle panel
Assembly Tips: For convenience in assembly, remove
the chute from the carton and lay it on top of the engine.
Do not unwrap the chute till you have installed the
handle panel and the clutch cables.
AttachingHandle
(Hardware Group A)
• Place right handle in position against the snow
thrower so the flat side of the handle is against the
snow thrower. Secure bottom hole in handle to
snow thrower using 3/4" hex bolt and lock washer.
Do not tighten at this time. See Figure 2.
Guide
2" Hex
Washers 3/4" Hex
Bolt
Figure 2
• Place handle tab over the upper hole on the handle
so the curve in the handle tab matches the curve of
the handle. See Figure 2. Secure to the snow
thrower using 2" hex bolt and lock washer; do not
tighten at this time. Repeat on the other side. Do
not tighten at this time.
• Place the handle panel in position between the two
handles. To hold the handle panel in place, depress
both controls against the handles. While continuing
to hold the right control, release the left control (the
auger control lock will keep left control engaged).
See Figure 3.
• Fasten right side of the handle panel by inserting
two carriage bolts through handle and handle panel
(bolts must go through both the plastic and metal
parts of the handle panel). See Figure 3. Secure
with cupped washers (cupped side against handle
panel) and lock nuts.
• Repeat on the other side.
Loading ...
Loading ...
Loading ...