Loading ...
Loading ...
Loading ...
• With traction control engaged, the friction wheel
must contact the drive plate. See Figure 15.
Friction
Wheel
Gear Shaft
Drive
Figure 15
If adjustment is necessary:
• Loosen the jam nut on the traction drive cable and
thread the cable in or out as necessary.
• Retighten the jam nut to secure the cable when
correct adjustment is reached.
• Reassemble the frame cover.
NOTE: Ifyou placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
ShiftRod
To adjust the shift rod, proceed as follows.
• Remove the hairpin clip and flat washer from the
shift handle under the handle panel.
• Place shift lever in sixth (6) position or the fastest
forward speed.
• Push shift arm assembly down as far as it will go.
• Rotate the ferrule up or down on the shift rod as
necessary until the ferrule lines up with the upper
hole in the shift lever. See Figure 16.
Hairpin Clip_
;hiffRod
Shift Arm
Assembly
\\
\
Hairpin Clip
Figure 16
• Insert ferrule into the upper hole in shift lever.
• Reinstall the hairpin clip and the washer.
IMPORTANT:Check for correct adjustment of the shift
lever as instructed on page 13, before operating the
snow thrower.
ChuteAssembly
The distance snow is thrown can be adjusted by
changing the angle of the chute assembly. To do so,
stop the engine by removing the ignition key and loosen
the plastic wing knobs found on either side of the
discharge chute. Pivot the chute upward or downward
before re-tightening the wing knobs.
SkidShoes
The space between the shave plate and the ground can
be adjusted. For close snow removal, place skid shoes
in the low position. Use middle or high position when
area to be cleared is uneven.
• Adjust skid shoes by loosening the four hex nuts
and carriage bolts and moving skid shoes to
desired position. Make certain the entire bottom
surface of skid shoe is against the ground to avoid
uneven wear on the skid shoes. Retighten nuts and
bolts securely.
Carriage Bolts
Skid Shoe
Figure 17
WARNING: Do not operate this snow
thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing injury to the operator and/or damage
to the snow thrower.
AugerControl
Refer to AugerControlTeston page 12 to adjust the
auger control.
14
Loading ...
Loading ...
Loading ...