Loading ...
Loading ...
Loading ...
• Using a wrench to hold the shaft, loosen, but do not
completely remove, the hex nut and bell washer on
left end of gear shaft. See Figure 25.
• Lightly tap the hex nut to dislodge the ball bearing
from the right side of frame. Remove the hex nut
and bell washer from left end of shaft.
• Slide the gear shaft to the right and slide the friction
wheel assembly from the shaft.
• Remove the four screws from the friction wheel
assembly. Remove the friction wheel rubber from
between the plates. See Figure 26.
• Reassemble new friction wheel rubber to the
friction wheel assembly, tightening the four screws
in rotation and with equal force.
Plates
Bearing
Screws
Hub
/
Friction Wheel Rubber
Figure 26
Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the shaft
through the assembly. Reassemble the wheels and
the frame cover.
SECTION8: 0FF-SEASONSTORAGE
WARNING: Never store engine with fuel in
tank indoors or in enclosed, poorly ventilated
areas where fuel fumes may reach an open
flame, spark or pilot light as on a furnace,
water heater, clothes dryer, or other gas
appliance.
If unit is to be stored over 30 days, prepare the
engine for storage following instructionsin the
engine manual.
• Remove all dirt from exterior of engine and
equipment.
• Follow lubrication recommendations on page 15.
NOTE: When storing any type of power equipment in
an poorly ventilated or metal storage shed, care should
be taken to rustproof the equipment, especially springs,
cables and all moving parts.
18
Loading ...
Loading ...
Loading ...