Loading ...
Loading ...
Loading ...
2. Use the arrow buttons and the OK button to move
through the menu structure
Installation > Advanced
> Corridor width
.
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor width
of 1-9.
Note: Make the corridor width as wide as possible for
a minimum risk of lines in the lawn.
4.2.8.4 Reversing distance
The reversing distance makes the product move in
reverse for a set distance, before the product starts to
cut the lawn.
To set the reversing distance
1. Do steps 1-3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow button and the OK button to move
through the menu structure
Installation > Advanced
> Reversing distance
.
3. Use the number buttons to set the distance.
4. Push the BACK button.
4.2.8.5 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 32 cm / 13 in. You can select a distance of
25-50 cm / 10-15 in.
Note:
If you change the distance for
Drive Past Wire
,
the distance will change along the boundary wire in all
parts of the work area.
To set the Drive Past Wire function
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow button and the OK button to move
through the menu structure
Installation > Advanced
> Drive Past Wire
.
3. Use the number buttons to set the distance.
4. Push the BACK button.
4.2.9 Settings
In settings you can change the general settings to your
product.
4.2.9.1 ECO mode
ECO mode
disables the signal in the boundary wire,
guide wire and the charging station, when the product is
parked or is charging.
Note: Use
ECO mode
to save energy and to prevent
interference with other equipment, for example hearing
loops or garage doors.
Note: To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product cannot be
started in the work area.
To set the ECO mode
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to move
through the menu structure
Settings > ECO mode
.
3. Push the OK button to select the
ECO mode
.
4. Push the BACK button.
4.2.9.2 Spiral Cutting
The product cuts the grass in a spiral pattern if the grass
is longer in an area.
Spiral cutting
can be set in 5 levels:
• Low-
• Low
• Mid
• High
• High+
The level sets how sensitive the product is to changes in
grass height.
Note:
Spiral cutting
is only started in the Main area
mode. Cutting in the
Secondary area
mode does not let
the product to start
Spiral cutting
.
Spiral Cutting
does not
start in slopes steeper than 15%.
To set the Spiral Cutting
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings > Spiral
Cutting > Use Spiral Cutting
.
3. Push the BACK button.
To set the level of Spiral Cutting
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings > Spiral
Cutting > Use Spiral Cutting > Intensity
.
28
- Product settings 1650 - 006 - 20.02.2023
Loading ...
Loading ...
Loading ...