Loading ...
Loading ...
Loading ...
2. Use the arrow buttons and the OK button to move
through the menu structure
Schedule > Overview >
Copy
.
3. Use the arrow buttons and the OK button to copy
the schedule setting. You can copy the schedule
settings day to day or for the full week.
4.2.3.4 To reset the schedule setting
You can remove all schedule settings and use the
factory setting.
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to move
through the menu structure
Schedule > Overview >
Reset
.
a) Push the arrow buttons to select
Current
day
to only reset the current day to factory
settings.
b) Push the arrow buttons to select
All week
to
reset all schedule settings to factory settings.
3. Push the OK button.
4.2.4 Cutting height
4.2.4.1 Adjust the cutting height
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
To set the cutting height
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Cutting height
>
Cutting height
.
3. Use the arrow buttons to set the cutting height.
4. Push the OK button.
4.2.4.2 TargetHeight
Use the TargetHeight function to lower the cutting height
from the maximum cutting height to the specified cutting
height gradually during 10 days. If you change the
cutting height manually during this time it will disable the
TargetHeight function.
To set the TargetHeight
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Cutting height
>
TargetHeight
.
3. Push the OK button to enable or disable the
function.
4. Push the BACK button.
4.2.5 Security level
There are 3 security levels for the product.
Function
Low Medium High
PIN code
X X
STOP button
pressed
X
Carried away
X
•
PIN-code
- The correct PIN-code must be entered
to get access to the menu structure of the product.
If the incorrect PIN-code is entered 5 times, the
product is locked for a time. The lock is extended
for each new incorrect try.
•
STOP button pressed
- The alarm goes off if the
STOP button has been pushed and the PIN code
is not entered in less than 30 seconds.
•
Carried away
- The alarm goes off if the product is
lifted.
4.2.5.1 To set the security level
Select 1 of 3 security levels for your product.
1. Do steps 1–3 in
To get access to the menu in the
display of the product on page 22
.
2. Use the arrow buttons and the OK button to move
through the menu structure
Settings > Security >
Security level
.
3. Use the arrow buttons and the OK button to select
the level of security.
4. Push the OK button.
4.2.5.2 To create a New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
1650 - 006 - 20.02.2023
Product settings - 23
Loading ...
Loading ...
Loading ...