Loading ...
Loading ...
Loading ...
EN-8
PREPARE THE LOCATION
NOTE
Before making cutouts, make sure there is
proper clearance within the ceiling, wall or cabinet.
Disconnect power.
Select a at surface for assembling the range hood.
Place covering over that surface.
Lift the range hood and set it upside down onto covered
surface.
If cabinet has recessed bottom, add
1.
2.
3.
4.
VENTING REQUIREMENTS
Wood filler strips
(recessed cabinet
bottoms only)
Wall
Cabinet
bottom
3” (7.6 cm)
3” (7.6 cm)
Fitting material is provided to secure
verify suitability of the materials in
accordance with the type of wall and cabinet.
Lift the range hood up under cabinet and determine
nal location by centering beneath cabinet. Mark on
the underside of cabinet the location of the 4 keyhole
mounting slots on the range hood (See slot dimensions
on page 6).
Install the 4 - 0.50 cm x 1.9 cm mounting screws in
pilot holes. Leave about ¼” (6.4 mm) space between
screw heads and cabinet to slide range hood into place.
¹⁄4”
(6.4 mm)
5.
7.
Set range hood aside on a covered surface.
Mark rear mounting screw hole locations.
wide filler strips. Length and
recess dimensions.
Four flat head wood screws or
"two - 2” (5.1 cm)
thickness determined by
machine screws with
washers and nuts to attach filler
strips in locations shown.
Install framing for hood rear support
If drywall is present, using the rear mounting screw
hole locations marked in the previous step cut away
enough drywall to expose 2 vertical studs at the rear
mounting screw holes locations. Install horizontal
support at least 4” X 2 ” between two wall studs at
the rear mounting screw holes location. The horizontal
support must be flush with the room side of the studs.
Use cleats behind both sides of the support to secure
to wall studs. Reinstall drywall and refinish.
IMPORTANT – Framing must be capable of supporting
100 lbs.
8.
Centerline of
Installation
Space
View From
Cleats
.
Mounting
Support
8-1/2” min. opening for ductwork
Rear
Use
NOTE: Make the drill holes on the thin area of the slot.
A
A. Drill pilot hole
6.
for top range hood support.
5/64” drill bit and drill 4 pilot holes as shown
the hood to most types of walls and cabinets.
However, a qualified technician must
2” x4” Min
A. Keyhole slot
A
A
Loading ...
Loading ...
Loading ...