Loading ...
Loading ...
Loading ...
Install Vent System
Install vent through the vent opening in upper cabinet
or wall. Complete venting system according to the
selected venting method. See “Venting Requirements”
section.
Use caulking to seal exterior wall or roof opening
around the cap.
INSTALL RANGE HOOD
(Ducted version)
Detach the 3¼” x 10” (8.3 x 25.4 cm) rectangular
1.
2.
1.
PREPARE THE LOCATION
A. 3¼” x 10” (8.3 x 25.4 cm) rectangular vent damper
A
vent
damper from the package.
Vent Damper Installation
Install 3¼” x
10” (8.3 x 25.4 cm) vent damper.
Attach to range hood using the indicated screws
provided in hardware kit.
If a vent damper is installed with a wall cap with
damper, check that they do not interfere with each
other. Remove the vent damper ap if
•
vent knockout A.
rear rectangular vent knockout B.
Power Supply Cable Installation
For direct wire installations, run the home power
supply cable according to the National Electric Code
or CSA standards and local codes and ordinances.
1.
For roof installations, remove the top rectangular •
For wall installations, remove the
NOTE
Do not reconnect power until the installation is
complete.
Before starting the installation, remove the
vent grill and grease filters.
Remove the screws from the
terminal box cover.
Remove terminal box cover
and set aside.
2.
A. Terminal box cover
B. Screw
A
B
they interfere.
EN-10
A. Top rectangular knockout
B. Rear rectangular knockout
A
B
Install the 3¼” x 10” (8.3 x
25.4 cm) rectangular vent
transition
A. 3¼” x 10” (8.3 x 25.4 cm)
rectangular vent transition
B. 6 - 0.40 x 0.80 cm screws
C. Rectangular vent knockouts
B
C
A
B
Loading ...
Loading ...
Loading ...