Broan ERV130 USER AND INSTALLER MANUAL

Loading ...

2.5 CONNECTING THE DRAIN (HRV ONLY)

Install the drain hose included and run it to a drain or a pail. This unit may generate a large amount of water

in cooler weather. It is necessary to install the drain hose properly to prevent water damage and/or material

damage.

CAUTION

• Cut the appropriate lengths of drain tubing (see illustration at right).

• Connect the tubings to the provided adaptor.

• Make a water trap loop in the tube to prevent the unit from drawing

unpleasant odors from the drain source.

• Add water in the loop to prevent noise or hiss.

• Make sure there is a distance of at least 2" between the unit and the

tubing loop (see illustration at right).

• Using the tie wraps provided, attach the tubing as illustrated below.

• Run the tube to the ﬂ oor drain or to an alternate drain pipe or pail.

• IMPORTANT: If using a pail to collect water, place the tube end

approximately 1" inside the pail in order to prevent water from being

drawn back up into the unit.

2.6 INSTALLING DUAL EXTERIOR HOOD USING TANDEM® TRANSITION KIT (OPTIONAL)

For units set at 110 CFM or less, a Tandem transition kit can be used instead of 2 exterior

hoods; but take into account this device will generate approximately an additional 0.2 in w.g.

static pressure depending on the installation.

The minimum joist opening needed to install the Tandem

transition is 9¾". The maximum

height of the Tandem transition is 8¾".

To connect the insulated ﬂ exible ducts to the Tandem transition (Exhaust air to outdoors

and Fresh air from outdoors), follow the instructions included with the Tandem transition kit

(part no.14690), included in IKSV1000 kit.

VR0003

Select TANDEM speed setting to use this transition kit with your unit. See section 4 for more details.

CAUTION

t2"(51 mm)

r1"(25 mm)

5 1/4" (133 mm)

9 3/4" (248 mm)

VO0296

Tie Wrap

Loading ...

Broan ERV130 Venmar by , Energy Recovery Ventilator, 131 CFM