Loading ...
Loading ...
Loading ...
REPLACE THE IMPELLER
STORE THE MACHINE
Use only approved replacement scrapers.
WARNING
Clean the machine before storage.
Make sure the motor is not hot
when you store the machine.
Make sure that the machine does
not have loose or damaged parts. If
it is necessary, do these steps/
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved
service center.
Store the machine in a dry area.
Make sure that children cannot
come near the machine.
4. Put in the screw ( ) and scraper and
tighten them.
1. Remove the 10 screws and side wear
pads that secure the right and left
side covers.
2. Remove the belt, unscrew the nut
and then remove the washer, large
pulley and washer.
4. Remove the bearing, impeller axle,
washer and old impeller. And then
remove the insert blocks from the
old impeller to the new impeller.
5.
6.
7.
8.
Reinstall the new impeller, impeller
axle, washer and bearing in order.
Reinstall the splint, nut with flat
washer and spring washer.
Reinstall the washer, large pulley and
washer. And screw the nut, reinstall
the belt.
Reinstall the 10 screws and side wear
pads that secure right and left side
covers.
* If you cannot find the solution to
these problems, please go to the
service center.
3. Unscrew the nut with flat washer and
spring washer, remove the splint. Do
the same operation on the other
side.
TROUBLESHOOTING
TECHNICAL DATA
09
https://www.altonindustries.com
10
info@altonindustries.com
Problem
Rated Voltage
/Current
Working Width
Working Depth
Throwing Distance
Roller Diameter
No Load Speed
19.5inch (495mm)
120V/15A
Double-insulated
construction
10inch (25mm)
6.8inch (173mm)
9m
3000RPM
Possible cause Solution
Adjust the height
of the handle and
make sure that
the knobs and
bolts are aligned
correctly.
The bolts are
not engaged
correctly.
The switch is
defective. Have the switch
replaced by an
authorized service
center.
The extension
cord is not
connected to
the plug.
Connect the plug
on the machine to
the extension cord.
The extension
cord is not
connected to
the power
source.
Plug the extension
cord into a live 120
V AC, 60 Hz outlet.
The handle
is not in
position.
The
machine
does not
start.
The belt is
damaged. Replace the belt.The engine
is on, but
the
impeller
does not
turn.
The scraper is
damaged. Replace the
scraper.
A thin layer
of snow
stays
behind.
belt
nut
washer
large pulley
Splint
Bearing
Washer
Insert blocks
Impeller
Impeller axle
21
Loading ...