Loading ...
Loading ...
Loading ...
STOP THE MACHINE
ADJUST THE DISCHARGE CHUTE
OPERATION TIPS
GENERAL MAINTENANCE
REPLACE THE SCRAPER
ADJUST THE CHUTE DEFLECTOR
Keep bystanders a safe distance from
the machine.
WARNING
Examine the work area. Remove all
stones, sticks, wire, bones, and other
debris that can ricochet because of the
rotating impeller.
WARNING
Wait until the impeller fully stops before
you start the machine again. Do not
quickly turn the machine off and on.
WARNING
Pull the plug after you complete the
work.
WARNING
Release the bail lever before you adjust
the chute deflector.
WARNING
Do not push the deflector so far forward
that a gap shows between the deflector
and the chute.
WARNING
Disconnect the extension cord before
maintenance.
WARNING
Use only approved replacement scrapers.
WARNING
Wear heavy gloves or wind cloth around
the impeller when you touch the impeller.
WARNING
Use only approved replacement parts.
CAUTION
Do not use strong solvents or detergents
on the plastic housing or components.
CAUTION
Lower the scraper to the ground to
remove the snow.
NOTE
You can adjust the discharge chute
180° to change the snow direction.
You can adjust the chute deflector up
and down to change the throwing
distance of the snow.
While holding the safety switch
button ( ), pull the start lever ( ) to
start the machine.
Once the machine powers on,
release the safety switch button ( )
and begin operation.
The machine can only be started by
pressing the safety switch button ( )
first, followed by squeezing the start
lever ( ), reverse operation will not
start the machine.
1.
2.
3.
Release the start lever ( ) to stop the
machine.
1.
1.
2.
3.
Turn the grip handle ( ) left to
move the discharge chute ( ) to the
left.
Turn the grip handle ( ) right to
move the discharge chute ( ) to the
right.
1.
2.
Loosen the locking knobs ( ) and
adjust the chute deflector ( ) to a
suitable height.
Move the chute deflector ( ) up or
down to selected comfortable angle.
Tighten the locking knob ( ).
1.
2.
3.
If it is possible, clear the snow with
the direction of the wind.
In strong winds, lower the chute
deflector to direct the snow to the
ground.
When you complete the work, let
the machine operate for a while to
prevent ice formation in the
discharge chute.
If the snow is deeper than 8",
decrease the speed and let the
machine work at its own rhythm.
Do not use the scraper to remove
compact snow and ice.
Before each use, examine the
machine for damaged, missing, or
loose parts such as screws, nuts,
bolts and caps.
Tighten correctly all the fasteners
and caps.
Clean the remaining snow on the
machine with a brush.
Remove the 6 screws ( ) .
Remove and discard the old scraper.
Install the new scraper.
MAINTENANCE
07
https://www.altonindustries.com
08
info@altonindustries.com
2
2
90° 90°
23
10
10
11
14
21
12
12
12
23
23
10
14
14
11
11
21
10
2
2
2
Loading ...
Loading ...