T100 carving machine instruction
Product performance, features and uses:
The new type of tyre carve machine adopts advanced intelligent temperature
adjustment, voltage overload protection, air cooling technology, low voltage electric
touch technology, power line to more capacitive power line plus PV material package
insulation waterproof. The fuselage is made of impact resistant corrosion resistant
material, high temperature resistant material handle, easy to use, low power
consumption and good thermal effect. The use of DC power supply, the use of safety.
Product Name:
Tire carve machine
Product model:
T100
Product specifications:
Package size: 380*280*250mm
Power voltage:
350W/AC110v
Description of product use
1, check whether the power supply meets the standard voltage of the machine.
2. Please put the machine in a stable place.
4, install the blade, (do not reverse the blade, knife edge up) open the main power supply,
5, hold the handle, the blade contact with the rubber (tire). When the blade is cut to the
glue, the hand pushes the handle to the handle. (the machine is pulse heating. The blade
should contact with the tire and push forward in a moment, that is, it is hot, when the blade
is loosened, the blade is not heated).
Operation steps:
1、first check whether the machine is damaged.
2、please check whether the voltage meets the standard 110V voltage.
3、open the power switch, twist the gear to 3 gear (from small to large, 3
for average), then twist the temperature adjustment switch in the middle
position, see whether the indicator on the upper board is bright.
4、machine installed blade please note: the two copper contact pieces of the
blade can not be touched together (easy to damage together).
5、operation carving machine method: after the electricity, hold the end of
the handle, a little force, the front blade position downward pressure 3-5
seconds, see if the blade is in the heating state, the blade temperature should
not be too high, to avoid burning bad oxidation layer, this time set the
temperature switch, start normal operation, in the operation process, hand
pressure degree reached mean It is appropriate to balance the state.
6、when carving, first do not push forward, but use a certain intensity,
because the blade should be closed, and the force should be uniform.
Matters needing attention:
(1) when pulling off the plug, be sure to hold the plug. Do not grab the power cord to
pull it.
(2) do not put heavy objects on the power supply, do not let the power cord be
squeezed.
(3) if the power cord is damaged, to avoid danger, it must be replaced by the
manufacturer or its maintenance department or similar full-time staff.
(4) do not use wet hand to plug power plug, so as not to plug power plug.
(5) do not plug in the power plug where there is a gas leak.
(6) use standard and reliable AC grounding receptacle.
(7) when the carving machine is not used, pull the plug of the power cord from the
socket.
Possible problems：
(1) It is normal to turn on the switch blade without heating after receiving the goods.
It is necessary to rotate temperatu regulation to adjust it to the middle position, and
the gear switch to the third gear. At this time, it is normal to push the handle blade to
heat
