Loading ...
Loading ...
Loading ...
Near start of timeline Center of timeline
Towards end of timeline End of timeline
Position mode lights indicate your
position relative to the timeline
NOTE When using ‘position’ with a tape based deck, the position indicator will
improve with time as the deck is queried by the controller.
To locate your timecode point, make sure your ‘player’ has a reference signal and is in ‘remote’
mode. Then on the controller:
1 Press the ‘player’ button if it is not already illuminated
2 Press the ‘shuttle’ button. Once pressed, the button will illuminate.
3 Rewind your tape by turning the search dial knob to the left until you feel the clutch
engage. You are now rewinding at full speed and the tape will be spooling back to
the start.
4 Once you are nearing the timecode point, turn the dial back to the center. Once the
knob is near the center stop position you will feel a tap on the dial to let you know.
5 Press the ‘jog’ mode button. The jog button will now be illuminated. The dial will now
spin freely and you can turn it to find your desired timecode. The faster you turn the
dial, the faster the media will jog.
Now that you have found your timecode in point, you can use the four soft touch timecode
buttons to define your in and out timecode points. These timecode entry buttons operate the
same way as they do on traditional broadcast decks.
To set your timecode points:
1 Press ‘entry’ and ‘in’ to select your in point and release the buttons. The ‘in’ button
willbe illuminated to confirm an ‘in’ point is selected.
TRIMIN
OUT
ENTRY
DELETE
ENTRY
Press the entry and in buttons to set your in point
2 Now you can use the transport controls or search dial to locate your ‘out’ point. Once
you have found your out point, set it by pressing the ‘entry’ and ‘out’ buttons together.
Both the ‘in’ and ‘out’ buttons will now be illuminated.
61HyperDeck Extreme Control Workflow
Loading ...
Loading ...
Loading ...