Loading ...
Loading ...
Loading ...
To select multiple playback decks, hold down the M button so it
illuminatesand then press the deck numbers you wish to select.
Controlling your playback andrecord decks
Once your playback and record decks are connected and selected, you will be able to switch
control between the two by using the soft touch ‘player’ and ‘recorder’ buttons on the front
panel above the status indicators. When remote is enabled, you can then use the search dial
and transport controls to navigate to the location on your deck.
1 Press the soft touch ‘player’ button and the player button will illuminate. The timecode
display and deck status indicator LEDs on the controller will update to show the ref,
servo and remote status of the playback deck. If you press ‘recorder’, the displays will
update to show the status of the HyperDeck recorder.
PLAYBACK
RECORD
TRIM PLAYER
REF
SERVO
REMOTE
RECORDER
HOURS MINUTES SECONDS FRAMES
IN
INPUT PREROLL SKIP REC SKIP
SHUTTLE JOG POSITION
EDIT EJECT REW PLAY F FWD STOP
OUT
ENTRY
DELETE
M
M
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
M
M
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1
2
When the ‘player’ button is selected, the timecode display will
update to match the deck selected as player. The deck status lights
will also update to reflect the settings of the connected device.
2 The deck status indicators to the left of the search dial display the conditions of the
active player or recorder.
Ref A valid reference signal is important to maintain synchronous timecode between
the connected decks. If the ‘ref’ status signal is unlit, your deck doesn’t have a
reference signal that matches your format. Connect a cable from the ref out of the
controller rear panel to the ref in on your deck.
Servo An illuminated servo light indicates that the tape deck is in playback or record
mode. Ifyour deck is idle, you may need to press a button on it to establish the
servo status.
Remote The remote LED lets you know whether the remote switch on the connected deck is
on or off. If the ‘remote’ indicator is not illuminated, this means your connected deck
is not in remote. While you can see the status of the deck and the timecode, you will
be unable to control the deck with the transport buttons or search dial. The location
of the remote button orswitch on traditional broadcast decks can vary. If you are
unable to locate the remote button or switch, refer to your deck’s manual.
58HyperDeck Extreme Control Workflow
Loading ...
Loading ...
Loading ...