Loading ...
Loading ...
Loading ...
Timing the First and Second
Place Finishers
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
D
A
D
2nd Finisher*
1st Finisher*
Start
* This displays the time of the first
finisher.
●
Elapsed time is shown in 1/100-second
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
Hour, minute, secondMinutes, seconds,
1/100 seconds
First hour After first hour
3. Press (A) to display the time of the second
finisher.
4. Press (A) to reset the elapsed time to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set the timer
start time.
l
Configuring Watch Settings
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Hours
3. Use (B) and (D) to change the timer hours
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4. Press (C).
This causes the minutes digits to flash.
Minutes
5. Use (B) and (D) to change the timer
minutes setting.
6. Press (C).
This causes the seconds digits to flash.
Seconds
7. Use (B) and (D) to change the seconds
setting.
8. Press (A) to exit the setting screen.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Setting a start time of [0:00 00] will
perform a countdown of 24 hours.
Watch Operation Guide 3501
23
Loading ...
Loading ...
Loading ...