Loading ...
Loading ...
Loading ...
3. Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
4. Use (B) and (D) to change the hour setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (C).
This causes the minutes digits to flash.
Alarm minute
6. Use (B) and (D) to set the minute setting.
7. Press (A) to exit the setting screen.
●
(alarm) is shown on the
display while an alarm is turned on.
●
To stop the alarm
Pressing any button while the beeper is
sounding stops it.
Note
●
A beeper sounds for 10 seconds when
an alarm time is reached.
●
The watch will automatically return
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Enabling the Hourly Time
Signal
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to display the hourly time signal
screen ([SIG]).
3. Press (A) to toggle the hourly time signal
between enabled (on) and disabled (off).
●
(hourly time signal) is shown on
the display while the hourly time signal
is turned on.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
Snooze
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (D) to scroll through the alarm ([1] to
[4], [SNZ]) and hourly time signal ([SIG])
screens until the one you want to turn off
is displayed.
Alarm or hourly time signal
3. Press (A) to turn off the displayed alarm or
the hourly time signal.
●
Each press of (A) toggles between ON
and OFF.
●
Turning off all alarms causes
(alarm) to disappear from the display.
Turning off the hourly time signal
causes (hourly time signal) to
disappear.
Note
●
If (alarm) is still displayed
after you turn off an alarm, it means that
at least one of the other alarms is still
turned on. To turn off all of the alarms,
repeat steps 2 and 3 until the
(alarm) indicator is no
longer displayed.
Watch Operation Guide 3501
21
Loading ...
Loading ...
Loading ...