Loading ...
Loading ...
Loading ...
TOREMOVEBLADE
See Figure 6.
• Remove batter/pack from saw,
WARN ING: Failuretoremove battery backfrom
sew couldresultinaccidental startingcausing
possiblesedouspersonalinjury.
mRemove bladewrenchfrom storagearea. See/:?gum 1.
•Positionsew as shownin figure5, depress spindlelock
button,and remove bladescrew.
Note; Turnblade screwclockwiseto remove.
M Removeouterbladewasher.See F/gum5.
Note: Bledo can be removed at this point.
DEPRESSSPINDLE
LOCKBUTFON
LOOSEN
SCREW
BLADE
WRENCH
TO
TIGHTEN Fig. 6
TO INSTALL BATTERY PACK
See Figure 7.
Note: Batterypack isshippedin a lowchargecondition,
Therefore, it mustbecharged pdorto use. Refer to page
10, =CHARGING BATTERY PACK" for charging
instructions,
•Place battery back inyour sew.Alignraiseddb on
batteryback with grooveinside sew, then slidebattery
packin saw as showninfigure7,
•Make sure the latcheson each sideofyour battery
back snap intoplace and batterypack issecured in
saw beforebeginningoperation,
CAUTION: When placingbatteryback in yoursew,
be sure raisedfib on battery back alignswithgroove
insidesaw end latchessnap intoplace properly,
Improperassemblycan cause damage to sew and
battery peck.
LATCHES
BATrERYPACK Fig.7
BLADE GUARD SYSTEM
The lower blade guard attached to your tdm sew is
there for your protection and safety. It should never be
altered for any mason. If it becomes damaged or
begins to mtum slow or sluggish, do not operate your
sew until the damage has been repaired or replaced.
Always leave guard in operating position whon using
SaW.
_k DANGER: When sewing through workpiese,lower
bladeguard does notcover bladeon the underside of
workpiece,Since bladeise_pesed on undersideof
workpiece,keep handsand fingersawayfrom cutting
area. Any partofyourbodycoming in contact with
moving bladewillresultinserious injury,
See Figure8.
LOWERBLADEGUARD
ISIN UP POSITION
WHENMAKINGA CUT
BLADEEXPOSEDON
UNDERSIDEOFWORKPIECE Fig. 8
Never usesew whenguard isnot obamtingcorrectly.
Guard shouldbecheckedfor correct operationbefore
each use. Ifyou dropyoursew, checkthe lowerblade
guardand bumperfor damage at all depthsettingsbefore
reuse. Note:The guardisoperatingcorrectly when it
movesfreely and readilyratums to theclosedposition. If
for any reasonyour lowerblade guard does notclose
freely, take itto the nearestSears Partsand RepairCenter
for servicebeforeusing,
13
Loading ...
Loading ...
Loading ...