Craftsman 315114231 Official Trim Saw

User Manual - Page 11

For 315114231.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
WARNING: Do notallowfamiliaritywith yourtrim
sew tomake you careless.Rememberthat a
careless fraction ofa secondis sufficientto inflict
severe injury.
BATTERY PACK
The batterypeck for yourtoolhas bean shippedin a low
chargecondition to preventpossibleproblems.Therefore,
you shouldchargeituntillightonfront ofchargerchanges
from redto green,
Note: Batterieswillnutreach fullchargethe firsttimethey
are charged,Allowseveral cycles(cuttingfollowed by
recharging)for them to becomefully charged,
CHARGING BATTERY PACK
See Figure2.
Charge battery peckonlywiththe chargerprovided.
Make sure power supply is normal household
voltage, 120 vo#s, 60 Hz, AC only.
Connectchargerto powersupply.
Place batterypack inchargeraligningraisedribon
battery peck with groovein charger.See Ffgure2.
Pressdownon battery packto be surecontacts on
battery peck engage probedywithcontacts incharger,
Normally,the red LED on chargerwillcome on,This
indicatescharger isinfast chargingmode,
Red LED shouldremainon for approximately1 hour
thanthe green LED willcome on, Green LED on
indicatesbatterypeck isfully chargedand chargerisin
tdckiechargemode, Note: Green LEDwill remainon
untilbatterypeck is removedfrom chargeror charger
isdisconnectedfrom powersupply,
If bothyellowand green LED comaon, thisindicatesa
deeplydischargedor defectivebatterypack.
Allowbatterypack to remaininchargerfor 15 to30
minutes.When batterypack rsaches normalvoltage
range, red LED shouldcoma on.
If red LED does nutcomeon after30 minutes,this
indicatesa defectivebattery peck and shouldbe
replaced.
After normal usage,a minimumof 1 hour ofcharging
time isrequiredtofully recharge batterypeck.
The batterypeck willbecome slightlywarmto the
touchwhilecharging.This isnormaland does not
indicatea problem.
Do not place chargerand batterypackinan area of
extreme heator cold, Itwillwork best at normal room
temperature,
Note: Charger and batterypack shouldbe placedin a
locationwhere the temperature ismore than 50°F but
lessthan 100=F,
When battedesbecomefully charged,unplugcharger
from power supplyand removethe batterypack.
LED FUNCTIONS OF CHARGER
LED WILL BE ON TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
Red LED on = Fastchargingmode.
Green LED on = Fullychargedand intricklecharge
mode,
Green LED on = When batterypackisinsertedinto
charger,indicateshutbatterypack or that batterypack
isout ofor belownormaltemperaturerange.
Yellowand Green LEDs on= Deeplydischargedor
defectivebatterypeck.
No LED on =Defectivechargeror batterypeck.
_, CAUTION: To preventdamage to batterypack,
removebattery peck from charger immediatelyif no
LED comes on. Ratum battery peck and charger to
your nearestSeers Service Canterfor checkingor
replacing,Also, ifyou are removingbatterypeck from
chargerand no LEDs am on, return bothbatterypack
and chargertoyour nearestSears Service Center,
Do nut Insert another batterypeck Into charger.A
damagedcharger maydamage a better/peck.
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERY PACK
When usingyourtdm sew continuously, the batteriesin
your batterypeck willbecome hot.You shouldlet hot
batterypack cool downfor approximately30 minutes
before attemptingto recharge,When the batterypeck
becomes dischargedand is hot,thiswillcause thegreen
LED to comaon insteadofthe red LED.After 30 minutes,
reinsert batterypeck incharger.If green LED continuesto
remainon, ratum batterypeck toyour nearestSears
Repair Centerfor checkingor replacing.
Note: This situationonlyoccurswhen continuous useof
your saw causes the bettedas to become hot.It does not
occurundernormal circumstances.Refer to"CHARGING
BAI'TERY PACK" for normalrecharging of bettafias. If
the charger does notchargeyourbattery peck under
normal circumstances,return both thebattery peck and
chargertoyour nearestSears RepairCenter for electrical
check.
IMPORTANT INFORMATION FOR RECHARGING
COOL BATTERY PACK
If batterypack is belownormaltemperaturerange, the
green LED on chargerwillcome on.Allow batterypeck to
reach normaltemperature,than the red LED willcome on,
Note: Refer to "CHARGING BATTERY PACK" for
normal rechargingofbatteries. Ifthe chargerdoes not
chargeyourbattery peck undernormalcircumstances,
returnboth the batterypack and chargerto yournearest
Sears Repair Center for electricalcheck.
11
Loading ...
Loading ...
Loading ...