Loading ...
Loading ...
Loading ...
Care and cleaning
12
• Before cleaning, always ensure the deep fryer is
turned off and disconnected from the power outlet,
• Ensure the deep fryer and oil are completely cool.
Oil will retain its temperature for a long time after
use. Do not attempt to move or carry the deep
fryer, element or control panel while they are hot.
• Wash the frying basket in hot soapy water. Rinse
and dry thoroughly.
• Remove the control panel/element of the deep
fryer by lifting upwards. Place the element onto
kitchen paper to absorb excess oil. Wipe element
with a soft, damp cloth and dry thoroughly.
• Grasp each side of the removable frying bowl and
lift upwards.
• Empty the cooled oil from the frying bowl. Oil can
be re-used several times, depending on the type of
food cooked. Filter the oil through a fine sieve.
Oil should be filtered after each use and stored
in a clean, air-tight container in a cool area.
Good quality oil can be used several times. Do
not store the oil in the deep fryer. Discard used
oil in a sealed container with household waste.
Do not pour down a sink or drain.
Note
• Wash the lid, removable enamel frying bowl, stainless
steel outer body and wire frying basket in hot soapy
water, rinse and dry thoroughly The removable
enamel bowl frying allows for easy cleaning. Wipe the
bowl with absorbent paper, then a damp cloth and a
little mild detergent. Finish off with a clean damp
cloth followed by a clean dry cloth.
• The removable enamel frying bowl, frying basket
and stainless steel outer body are dishwasher safe.
Do not use any abrasive cleaners, such as steel
wool to clean the surface of your deep fryer as
this will scratch the coating.
Note
• Wipe over the control panel with a soft, damp
cloth and a little mild detergent. Finish off with a
clean damp cloth and dry thoroughly with a clean
dry cloth.
• Reassemble the deep fryer for storage. Do not
place anything on top of the deep fryer
during storage.
NEVER IMMERSE THE DEEP FRYER CONTROL PANEL, ELEMENT OR CORD IN WATER OR ANY
OTHER LIQUID.
ALWAYS TURN THE APPLIANCE OFF AT THE POWER OUTLET AND THEN UNPLUG CORD BEFORE
ATTEMPTING TO MOVE THE APPLIANCE AND BEFORE CLEANING.
DO NOT, UNDER ANY CIRCUMSTANCES, IMMERSE THE CONTROL PANEL/ELEMENT, THE POWER
CORD OR PLUG IN WATER OR ANY OTHER LIQUID.
BDF450_IB_FA.qxp:Blender 12/1/10 2:21 PM Page 12
Loading ...
Loading ...
Loading ...