Loading ...
Loading ...
Loading ...
8
SPECIFIC SAFETY RULES FOR AIRLESS PAINT SPRAYER
Maintain labels and nameplates. These carry important safety information.
Never spray materials near fire, flames, electrical sparks, or any other ignition source. Never smoke
when spraying or in the vicinity of spraying. Always provide good ventilation. Vent during and after
spraying to eliminate any enclosed explosive atmosphere.
For units intended for use with only water-based materials-Do not spray or clean with flammable
liquids. For use with water-based liquids only.
Do not painting in rainy weather, severe cold (below 5℃), high temperature (above 40℃), high wind
speed and other weather conditions. Please do not construct when the air humidity is greater than
85%.
Paint or solvent flowing through the equipment is able to result in static electricity. Static electricity
creates a risk of fire or explosion in the presence of paint or solvent fumes. All parts of the spray
system, including the pump, hose assemble, spray gun, and objects in and around the spray area shall
be properly grounded to protect against static discharge and sparks. Use only conductive or grounded
high-pressure airless paint sprayer hoses specified by the manufacturer.
Verify that all containers and collection systems are grounded to prevent static discharge.
Connect to a grounded outlet and use grounded extension cords. Do not use a 3 to 2 adapter.
Keep spray area well ventilated. Keep a good supply of fresh air moving through the area. Keep
pump assembly in a well ventilated area. Do not spray pump assembly.
Do not operate light switches, engines, or similar spark producing products in the spray area.
Keep area clean and free of paint or solvent containers, rags, and other flammable materials.
Know the contents of the paints and solvents being sprayed. Read all Material safety Data Sheets
(MSDS) and container labels provided with the paints and solvents. Follow the paint and solvent
manufacturer’s safety instructions.
Fire extinguisher equipment shall be present and working.
Do not aim the gun at, or spray any person or animal.
Keep hands and other body parts away from the discharge. For example, do not try to stop leaks with
any part of the body.
Only use a nozzle tip specified by the manufacturer.
Use caution when cleaning and changing nozzle tips. In the case where the nozzle tip clogs while
spraying, follow the manufacturer’s instructions for turning off the unit and relieving the pressure
before removing the nozzle tip to clean.
High-pressure spray is able to inject toxins into the body and cause serious bodily injury. In the event
that injection occurs, seek medical attention immediately.
This system is capable or producing 20.7Mpa. Only use replacement parts or accessories that are
specified by the manufacturer and that are rated a minimum of 22.8Mpa.
Know how to stop the unit and bleed pressure quickly. Be thoroughly familiar with the controls.
Always wear ANSI-approved safety goggles and NIOSH-approved ventilator or face mask. Some
face masks, such as paper filters, provide only limited protection against harmful sprays and fumes.
refer to the safety documents provided with the materials you are spraying or an industrial safety
expert when determining the appropriate respritory protection.
This high-pressure airless sprayer is capable of producing 3,000 PSI and is capable of injecting
toxins into the body and cause serious injury. In the event accidental injection occurs, seek medical
attention immediately.
Never place your hands, fingers or any part of your body in front of the spray nozzle if the spray gun
is not disconnected and depressurized.
Test spray on scrap material before spraying work material. High pressure spray may damage
persons or property.
Loading ...
Loading ...
Loading ...