Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTION
WARNING: Read and thoroughly understand all instructions and safety information
before operating this tool. Failure to do so may cause serious injury or death. Do not allow
anyone to operate this tool who has not read this manual. The tool can be dangerous if
assembled or used improperly. Do not operate this tool if you have doubts or questions concerning safe
operation. Call our customer service department at 1-800-791-9458 to address these concerns.
BEFORE STARTING
1. Check all fittings and connections in the pump system, hose, and gun to ensure that they are tight.
Check to ensure that there is a spray tip in the gun, and that the tip is the correct size for the coating you
are to spray. (There are various tips available, for each type of coating or configuration.)
2. Make sure the power source is securely grounded and match the motor rating of your sprayer.
3. New spray: Oil is used by the factory for testing and protection. It is necessary to flush unit before
spraying. Clean the pump with warm soapy water, Make sure the hydraulic oil in the pump is clean and
sufficient in volume then begin the following procedure.
Remove spray tip from gun.
Put the input hose and pressure relief tube into the bucket with some water.
Turn on the motor and push the pressure valve upright. In a few seconds, water will begin to flow up
through the tube and flow out from outlet valve, tighten the outlet valve deasil, then tighten the
pressure valve deasil.
When the pressure reaches up to around 207bar, check if there is any leakage on the outlet hose, if it
is leak, Please check. Do not stop or deflect leaks with your hand, body, glove or rag.
If doesn’t leak, open the spray gun and have a testing spray. Clean the oil in pump. Change the soapy
water and use clean water when the spray is clean.
Turn off power, Continue to spray till no water out.
Unlock trigger lock. Put the pressure valve upright, till no soapy water in pump.
PRESSURE RELEASE PROCEDURE
Whenever instructed to relieve pressure, Stop spraying, Check or service equipment or install or clean
spray tip.
Engage trigger safety lock on gun. Turn Off power and turn sprayer pressure control to lowest
pressure setting.
Hold gun against side of flushing pail. Trigger gun into pail to relieve pressure.
Turn off pump and release fluid pressure by turning the pressure relief prime valve located on the
side of the pump down.
Loading ...
Loading ...
Loading ...