Loading ...
Loading ...
Loading ...
8
How to Assemble Your Ceiling Fan (continued)
7. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip
insulation
off
1/2 inch from the end of each lead wire. (Figure 7)
Canopy Screw
Cover
Ceiling
Canopy
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7
5. Route wires and safety cable through motor coupling
cover, canopy screw cover and ceiling canopy.
(Figure 5)
8. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Figure 8
Hanger Bracket
6. Reinstall the hanger ball on the downrod as follows.
Route the brown, blue, red, gray, yellow wires and
safety cable through the hanger ball. Position the pin
through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could cause fan
wobble. (Figure 6)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
Loading ...
Loading ...
Loading ...